10, Jalan Setia 4/6,
Taman Setia Indah,
81100 Johor Bahru, Johor.
Malaysia.
+607-3527113
+607-3516024
+6012-3085077
+60123085077
Sejati Teknik Sdn Bhd
10, Jalan Setia 4/6,
Taman Setia Indah,
81100 Johor Bahru, Johor.
Malaysia.
10, Jalan Setia 4/6,
Taman Setia Indah,
81100 Johor Bahru, Johor.
Malaysia.
11, Jalan TPK 1/9,
Taman Perindustrian Kinrara,
47100 Puchong,
Selangor, Malaysia.
Taman Perindustrian Kinrara,
47100 Puchong,
Selangor, Malaysia.
+603-8070 8975
+603-8070 8973Associated Companies:
KL- QTC Engineering Sdn Bhd
Penang- Dyna Air Sdn Bhd
Zgaiard SKY ZV75AX-R
| Previous | 2 / 3 | Next |
Smaller, Stronger, Sophisticated Outdoor Model
- Implemented a waterproof evaluation test for the package and achieved a protection class of *IP23.
- Starter ox raised structure
- Waterproof connectors are used for electrical component connections inside the compressor package.
- Oil fence structure An oil fence is installed to minimize oil leakage from inside the package.
*Waterproof and dustproof performance is specified based on IEC (International Electrotechnical Commission) or JIS (Japanese Industrial Standards) and is a protection grade display for electrical equipment against foreign matter and water intrusion.
specifications
| items | units | Model number: ZV75AX-R | |
|---|---|---|---|
| Power-supply voltage | 50/60Hz,V | 415 | |
| Discharge air volume | m3 / min | 13.4 (14.7)* | |
| Discharge pressure [adjustment range] | MPa | 0.7 [0.53 to 0.93] (0.5) * | |
| Suction conditions | Atmospheric pressure (2 to 40°C) | ||
| motor output | kW | 75 | |
| Motor type | Fully-enclosed fan-cooled permanent magnet rotor variable speed synchronous motor (IPM motor) | ||
| Starting method | Inverter start | ||
| Drive system | Coupling direct drive | ||
| cooling method | air cooling | ||
| fan motor output | kW | 3.7 (inverter control) | |
| Lubricating oil filling amount | L. | 38 | |
| dryer | outlet air dew point | ¡æ | 10 (under pressure)* |
| power consumption | kW | 2.3/2.7 | |
| Refrigerant used | R-410A | ||
| Refrigerant charge | g | 1450 | |
| Discharge air diameter | R. | 2 | |
| width x depth x height | mm | 2115 (including 2343=duct) x 1436 x 2290 | |
Note: Dryer for low pressure increased specification (option) is installed separately. Please contact us for the dimensions and mass of the dryer. *
: The value in () is the discharge air volume for the 0.5 MPa specification (option).
are based on ambient temperature of 30°C, humidity of 75%, and rated discharge pressure.
- Motor power represents nominal power.
-
The noise level is the value measured under full-load operation at a height of 1.0m and 1.5m from the front of the machine under anechoic conditions. (At 0.7 MPa) Depending
on the installation environment, it will be larger than the indicated value if it is affected by the surrounding reverberation.
It fluctuates during capacity control operation. Pressure settings other than 0.7 MPa may be larger than the displayed value. - Different voltage 400/415/440V is also available .